BEVEL GEAR BOX

Specifications

BEVEL GEAR BOX

* MATERIAL & FEATURE

1) MATERIAL

2) FEATURE
We have two kinds of manual bevel gear operator type, one is bevel gear and the other is bevel-helical gear. The latter was bevel-spur gear. It has been changed helical gear, because of soft rotating among the spur gears.
GENERAL TYPE ------- SB-VS10 SB-V8 (USED BEVEL GEAR)
SUPPORT BOX TYPE-1 - SB-V3-1 SB-V8-1 (USED BEVEL- HELICAL GEAR)
SUPPORT BOX TYPE-2 - SBV2-20 SBV8-20 (USED BEVEL- BEVEL GEAR)
SUPPORT BOX TYPE-3 - SBV2-20-1 SBV8-20-1 (USED BEVEL- BEVEL-BEVEL GEAR)



* INSTALLATION
1) Mounting to valve
If the bevel gear operator has been supplied with a hand-wheel, it is recommended that it is fitted to the gearbox before mounting on the valves. About that, be careful the P.C.D and tap size of gear box base.
2) Maintenance
Under normal operating conditions no maintenance is required for the bevel gear operator, but should the valve be taken out of service for overhaul, the bevel gear operator baseplate may be removed and the grease changed using on of the following recommended lubricants.
Manufacturer : Yong Kang CO.,LTD
Name : Grease(GRANT SUPER GREASE)
Temperature Range : -4°F284°F(-20°C+140°C)

* DEVICE OF OPERATION
1) HAND WHEEL : Hand-wheel can be located in quadrant, giving you good adaptability.
You can install very easily, attach the wheel to the pinion, and a nut a screw.
2) ACTUATOR : If you would like to increase RPM, you may use a actuator.
3) CHAIN WHEEL : Overhead or inaccessible valves, when equipped with this device, may be conveniently and safely operated from the floor.

GENERAL TYPE-HORIZONTAL TYPE-1 Stair Specifications - SB-VS10~SB-VS20 - SB-V0~SB-V2 - SB-V3~SB-V5 - SB-V6~SB-V8	SUPPORT BOX TYPE HORIZONTAL TYPE - 2 Stairs Specifications - SB-V3-1~SB-V6-1 - SB-V7-1~SB-V8-1
SUPPORT BOX TYPE VERTICAL TYPE - 2 Stairs Specifications - SBV2-20~SBV8~20	SUPPORT BOX TYPE HORIXZONTAL TYPE - 3 Stairs Specifications SBV2~20-1~SBV8~20-1

Factory Information