PCH Crusher Stone Crusher Hammer Mill Crushing Machine

Specifications

PCH Crusher Stone Crusher Hammer Mill Crushing Machine 

(1)  Introduction

PCH series ring hammer crusher is to crush the material by the high-speed rotating hammers. This ring hammer crusher has the characteristics of simple structure, large crushing ratio, and high production efficiency. It can be used to crush the dry or wet materials. It is used to crush the mid-hard and low-abrasive materials, whose compressive strength is not more than 100MPa, and whose moisture percentage is not more than 15%. The common materials are coal, salt, chalk, gypsum, limestone and so on. It is also used to crush the wood pieces, paper, and asbestos cement waste, which are fiber-structural, elastic and strong tenacity. Ring hammer crusher is not only used in aggregate or sand production line, but also in mineral selection process instead of cone crusher.

(2) Working Principle

PCH series ring hammer crusher is an impact rotor-type crusher with hammer ring. The materials are impacted and crushed by the high-speed rotating hammers after entering the chamber. The crushed materials get the impetus energy from the hammers, and then they will impact on the crushing plate. After the secondary crushing process, the materials fall on the sieve plate. Then the materials are crushed again after being sheared, extruded, and grinded, and then dropped out. Unbroken matters enter the metal collector, which are cleaned periodically.

(3) Features and Benefits

1 Energy-saving, fine output size

2 Higher efficiency and lower noise

3 Less dust pollution

4 The discharge opening can be adjusted according to customer’s requirements.

5 Inverted V-shaped sieve hole and difficult to be blocked

6 Mn13 cast steel screen deck, long service life

(4) Technical Data:

Note: The discharged material size can be chosen willfully within the 0-60mm scope. When it is below 15mm, the output should be 60% of the tabulation data; while it is 3mm, the material moisture does not surpass 10%, the output should be 30% of the tabulation data.

(5) Wear Parts and Average Service Life

(6) The Specifications We Should Know for Quoting

1 What is the raw material /processing stone?

2 The max input size?

3 Output size?

4 Output capacity?

Factory Information